Firmware 78.036.04 for S79H changes and improvements

Improvements and changes:

• Slideshow: The Screensaver menu has been extended by the function Slideshow. All pictures from the Screen-Saver folder are shown in idle mode one after the other.
  
• keypad illumination: The brightness of the keypad illumination is now adjustable in 5 steps
  
• 4 handsfree profiles: The handset now has 4 handsfree profiles:
  
  • Profile 1: Standard
    
  • Profile 2: For loud surroundings
    
  • Profile 3: Full duplex (only on a very good line)
    
  • Profile 4: Optimised for special connections
    

• Setting a handsfree profile: In idle status, you can set various handsfree profiles to optimally adapt your phone to your environment. ·
  
  • Profile 1: The optimum setting for most connections and set as default.
    
  • Profile 2: Optimum volume in handsfree mode. However, this means that the participants cannot speak at the same time as the person speaking is given preferential transmission (making two-way conversations difficult).
    
  • Profile 3: Optimises two-way conversations, both callers can hear each other, even if they talk at the same time.
    
  • Profile 4: Optimised for special connections. If the default setting (profile 1) does not provide optimum sound, please give this a try.
    

• additional display remark: If the display backlight is activated when the handset is not in the charger the customer is advised that this mode reduces the standby time significantly.
• Deleting all appointments for one day: With this new option the customer can delete all appointments for 1 day.
  
• picture CLIP with GAP bases: Picture CLIP is now supported on GAP bases. For other devices this depends on the software * Status display (e.g. AM1 = on ; INT 16) optimised
  
• The character set position of "CR" and "Space" have been moved from key "1" to key "0"
  

How to update: 

• Please start the software "Gigaset Quicksync" on your PC.
  
• You will find it on the internet at https://www.gigaset.com/hq/en/cms/PageQuickSync.html
  
• Please carry out the update of the Gigaset Quick Sync software if it is offered.
  
• Remove the battery cover from your Gigaset S79H handset.
  
• Connect the handset directly to your PC via a mini USB cable. (Do not connect the USB cable via a USB HUB to your PC; failures may occur).
  
• Leave the batteries in the handset and switch the handset on. If necessary the device driver software of your handset will be installed automatically on your PC.
  
• Choose “Connect handset automatically” in the Gigaset Quicksync window.
  
• When a connection is set up, the message “S79H connected (n) (nnnnnnnnnn)” appears. If a new handset firmware is available, a prompt automatically appears.
  
• The firmware will be installed on your handset in several cycles.
  
• Do not disconnect your handset until you see the message “Handset firmware has been updated successfully”.