How is a Repeater registered to a Base?

Carry out the following steps:

 

Switch off the Gigaset Repeater (disconnect the power plug).

Press the registration key on the base station repeatedly or select the relevant menu item until the base station is in registration mode. For more information, please refer to the operating instructions for your base station.

Switch on the Gigaset Repeater (connect the power plug).

The left LED on the Gigaset Repeater flashes continually. After a short while the LED stays on permanently indicating that registration is complete and that the unit is ready for operation.

PLEASE NOTE!

 

The Gigaset Repeater can be registered independently of the length of an audible registration tone or a display at the base station. If registration is not succesfull, the LED on the Gigaset Repeater will flash continuously. In this case, repeat the procedure.

Before registering the Gigaset Repeater once again (e.g. at a different base station), please reset the Gigaset Repeater beforehand as described below:

Switch off the unit (disconnect the power plug).

Switch on for 1 to 5 seconds and switch it off again.

Switch on for 25 to 35 seconds and switch it off again.