How is the Gigaset Repeater registered to base?

Please refer to the user guide of your phone to check whether your base station is suitable for operating the repeater and how to prepare it for registering the repeater.
Before starting registration, position the Gigaset Repeater directly adjacent to the base station and to a power connection. If you are already using Gigaset Repeaters, these must be switched on and positioned close to the base station for this registration procedure.

Automatic registration
Carry out the following steps:

  • Switch on Gigaset Repeater: Connect the power supply unit to a plug socket. Following this, the device will enter registration mode for 5 minutes.
  • Prepare the base station for registering the repeater, in the same way as you would to manually register a handset. Please refer to the operating instructions for your base station.

The repeater will automatically be registered to the base station. The LEDs will indicate whether registration was successful or unsuccessful.

Please note: Ensure that no other base stations in registration mode are located close to the Gigaset Repeater during this procedure.

De-registration

It may be necessary to de-register the repeater, for example if it has to be replaced. Information about this can be found in the operating instructions of your base station, or via the system menu of your phone e.g. C430/C430A, C530/C530A, CL660/CL660A, E630/E630A. For phones without a repeater system menu, the repeater can be de-registered using the Reset Repeater procedure.